1. Improper operation
When using the crusher, due to insufficient understanding of the working principle of the crusher, the normal production performance of the crusher itself cannot be exerted due to improper operation in daily production, which affects the production efficiency.
2 Material hardness
The harder the material, the harder it is to break, and the more serious the wear on the equipment. The crushing speed is slow, the crushing capacity is small, and the moderate material crushing effect is good.
3 Humidity of materials
When the water content in the material is large, the material is easy to adhere in the crusher, and it is also easy to block during the conveying process of the material, resulting in reduced crushing capacity and affecting normal production. Strictly control the humidity of materials when selecting materials, and reduce the humidity of materials by sunlight or air drying if necessary.
4 Fineness of material after crushing
A sense of accomplishment is a good way to resolve anxiety. A person with a sense of accomplishment will be full of strength and a sense of richness in his heart, and it is difficult for anxiety to defeat him. How to make yourself feel fulfilled? Constantly improving yourself is a good way. Quickly make a self-improvement plan, recharge in time, and use the recharged power in your work, and your sense of accomplishment will be born.
5 Material viscosity
The greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the crushing chamber in the crusher. If it cannot be cleaned in time, it will affect the working efficiency of the crusher, and in serious cases, it will affect the normal work of the crusher. Therefore, when selecting materials, it must be noted that the viscosity of the material cannot be too large. A
6 Composition of materials
The more fine powders in the material before crushing will affect the crushing, because these fine powders are easy to adhere and affect the transportation. Therefore, materials with a large amount of fine powder should be screened in advance, and the fine powder should be selected from the materials as much as possible, so as not to affect the normal operation of the crusher. A
7 hardware equipment
The better the wear resistance of the crushing parts of the crushing equipment (hammer head, jaw plate), the greater the crushing ability. If it is not wear-resistant, it will affect the crushing ability. In addition, the broken parts of the crusher must be regularly repaired. If it is damaged, it should be replaced in time to avoid affecting the normal work of the crusher. In actual operation, adjust the crusher according to the actual situation to achieve the large production efficiency of the crusher and release more production capacity.
https://www.stordworkshop.com/
